The recess roller set will save you hours of time fitting and will also improve how well the vinyl sticks in those troublesome recesses on commercial vehicles. Fitting is easy on the fingers with these!

How do they work? - The large soft rubber roller pushes heated vinyl into the recess, the smaller hard roller finishes by pushing into the corners of the tightest recess.

How to use? - Bridge over the recess with the vinyl film, then lightly heat the bridged vinyl including ether side of the bridge. With the larger roller roll down the center of the recess, reheating the vinyl as required, then roll the vinyl into corners of the recess making sure to leave a escape route for the air. Reheat the recessed area and then reroll with  the smaller roller to firmly fit the vinyl into the very corners of the recess.

Every wrapper's tool box should have a set!